Jan
23

Hardwood Floor Refinishing Can Bring Your House Back to Life

There comes a time in the life of a wooden floor where its shine will fade and it will no longer look new. You may find which waxing your floors is enough to get them looking wonderful again; however, you are going to probably have to learn hardwood floor refinishing if you’d like them to look like they did when you first had them installed. Keep in mind the fact that this is pretty hard work though, therefore a lot of people choose to employ a professional. If you’re the diy type though you will likely appreciate taking on a project like this.

(C) Rochester NY Hardwood Flooring

(C) Rochester NY Hardwood Flooring

Before starting to refinish hardwood flooring at home, first make sure that it’s the right course of action. This is a fantastic way to increase the value of your home, but isn’t always required. For instance, if your floor has only light scratches or a lackluster surface, it might simply need a top coat of finish to have it looking new again. Another possibility is your floor could be too far gone for even hardwood floor refinishing to be enough. When this happens whole planks in your floor might need replacing. If the boards seem soft, spongy, sags or are warped, then consider simply having them replaced.

Dull and dilapidated wooden flooring not only looks ugly but it’s hard to clean also. However, not all wood flooring requires total refinishing and just a mop of cloth and water would bring back its sheen. This could be tested by spilling some water on the damaged area; when the water forms small beads, then the polish hasn’t lost its protective coating and just a swipe of wet cloth is sufficient. However, if water percolates into the floor and turns darker in color, then it implies that the polish has lost its protective coating and the flooring requires refinishing.

The first step in the hardwood floor refinishing process is sanding away the old finish and stain. Together with revealing the bare wood, sanding levels the floor and helps expose the grain of the planks. Sanding and buffing can easily get rid of scratches, scuffs, and cracks, and generally boost the appearance of the wood. You or your floor contractor should sand many times, vacuuming between each pass and taking advantage of smaller-grit sandpaper each and every time.

After the sanding is done sweep the floor and finish it up using the shop vacuum. The floors need to be free of residue before you can stain the floor. Make sure that you stir the stain before using it to the floor to remove any bubbles that can result in a molted look. Make use of a brush to apply the stain slowly in the direction of the grain of wood. Soon after it dries you will need to seal the floors by using the roller to apply a thin, uniform layer of sealant again in the direction of the grain of the wood.

Speak Your Mind

*